How to assemble MALM Bed Frame Assembly Guide

MALM — MALM Bed Frame Assembly Guide

IIKEAassembly 0

Steps

Parts

Est. time

56–71 min

People

1-2

Difficulty

Hard

Tap any available step below to explore it in the 3D viewer.

What you'll need

All tools and parts for the full guide, with quantities when available.

PPentalobe

SSpudger

TTweezers

HHeat gun

Step-by-step instructions

Click a step to open it in 3D. Click any diagram to enlarge.

Attach glides to side panelsView in 3D

Attach 6 glides to the bottom edges of the side panels using a hammer.

Fig. 1 Enlarge

Install cam boltsView in 3D

Install 8 cam bolts into the side panels using the provided wrench.

Fig. 2 Enlarge

Insert wooden dowelsView in 3D

Insert 12 wooden dowels into the ends of the side rails.

Fig. 3 Enlarge

Install cam locksView in 3D

Insert 8 cam locks into the side rails and tighten with the hex key.

Fig. 4 Enlarge

Insert wooden dowelsView in 3D

Insert 5 wooden dowels into the top edge of the frame.

Fig. 5 Enlarge

Install cam boltsView in 3D

Install 4 cam bolts into the headboard panel.

Fig. 6 Enlarge

Attach headboardView in 3D

Attach the headboard to the frame using the 4 screws, then secure them with 4 nuts using the included wrench.

Fig. 7 Enlarge

Attach support railsView in 3D

Attach the support rails to the frame using 16 screws.

Fig. 8 Enlarge

Attach bracketsView in 3D

Attach 2 brackets to the frame using 4 screws.

Fig. 9 Enlarge

Attach center railView in 3D

Attach the center rail to the frame using 4 screws.

Fig. 10 Enlarge

Secure center railView in 3D

Secure the center rail with 4 additional screws.

Fig. 11 Enlarge

Install center supportView in 3D

Install the center support beam into the frame.

Fig. 12 Enlarge

Attach slat holdersView in 3D

Attach 8 slat holders to the frame using 8 screws.

Fig. 13 Enlarge

Place slatsView in 3D

Place the slats into the holders.

Fig. 14 Enlarge

Common questions

About the available product information.

TaskHow long does this guide take?

Most people finish in 56–71 min. Go step by step and keep tools nearby before starting.

TaskWhat tools do I need?

You need Pentalobe, Spudger, Tweezers, Heat gun.

ProblemWhat if a part does not line up?

Loosen the previous fasteners, align the part again, and only tighten fully after the connected pieces are seated correctly.

About

Brand

IKEA

Official and community guides for this brand.

Creator

Community

Structured from available product documentation and 3D guide data.