0
Unfold the StemView in 3D
Begin with handlebars in the folded down position.
How to assemble Lectric XP4 eBike User Manual
XP4 eBike — Lectric XP4 eBike User Manual
Tap any available step below to explore it in the 3D viewer.
What you'll need
All tools and parts for the full guide, with quantities when available.
PPentalobe
SSpudger
TTweezers
HHeat gun
Step-by-step instructions
Click a step to open it in 3D. Click any diagram to enlarge.
1
Unfold the FrameView in 3D
Stand near the frame where the battery is exposed. Grab the front and rear end of the bike. Lift the bike slightly off the ground and swing to the closed position.
2
Raise the StemView in 3D
Pull the handlebar stem to its upright position.
3
Lock the Frame LatchView in 3D
Push down the latch firmly until it locks into position. Pull on the latch to confirm that the latch has locked and that the frame cannot fold.
4
Lock the Stem LatchView in 3D
Push the latch in firmly until it locks in position.
5
Confirm Stem LockView in 3D
Pull on the latch to confirm it is locked and the handlebars cannot fold.
Common questions
About the available product information.
TaskHow long does this guide take?
Most people finish in 24–39 min. Go step by step and keep tools nearby before starting.
TaskWhat tools do I need?
You need Pentalobe, Spudger, Tweezers, Heat gun.
ProblemWhat if a part does not line up?
Loosen the previous fasteners, align the part again, and only tighten fully after the connected pieces are seated correctly.
About
Brand
Lectric
Official and community guides for this brand.
Creator
Community
Structured from available product documentation and 3D guide data.