How to assemble Hudson Crib Assembly Guide

Hudson Crib — Hudson Crib Assembly Guide

bbabylettoassembly 0

Steps

Parts

Est. time

44–59 min

People

1-2

Difficulty

Hard

Tap any available step below to explore it in the 3D viewer.

What you'll need

All tools and parts for the full guide, with quantities when available.

PPentalobe

SSpudger

TTweezers

HHeat gun

Step-by-step instructions

Click a step to open it in 3D. Click any diagram to enlarge.

Insert wooden dowels into base railsView in 3D

Insert wooden dowels (H4) into the ends of the short base frame rails (J).

Fig. 1 Enlarge

Attach base frame railsView in 3D

Connect the long base frame rails (I) to the short base frame rails (J) using bolts (H11) and lock washers (H6).

Fig. 2 Enlarge

Insert wooden dowels into base frameView in 3D

Insert wooden dowels (H4) into the top edges of the assembled base frame.

Fig. 3 Enlarge

Insert wooden dowels into feetView in 3D

Insert wooden dowels (H4) into the top of the feet (G).

Fig. 4 Enlarge

Attach feet to base frameView in 3D

Attach the feet (G) to the underside of the base frame (I) using bolts (H2) and lock washers (H6).

Fig. 5 Enlarge

Attach side panels to baseView in 3D

Attach the left side panel (A-1) and right side panel (B-1) to the base frame (J) using bolts (H2) and lock washers (H6).

Fig. 6 Enlarge

Attach front/back panel to baseView in 3D

Attach the front/back panel (C) to the base frame (I) using bolts (H2) and lock washers (H6).

Fig. 7 Enlarge

Secure side panels to front/back panelView in 3D

Secure the side panels (A-1, B-1) to the front/back panel (C) using bolts (H1), lock washers (H6), and washers (H12).

Fig. 8 Enlarge

Install mattress supportView in 3D

Install the mattress support (D-1) inside the crib using bolts (H3).

Fig. 9 Enlarge

Attach second front/back panelView in 3D

Attach the second front/back panel (C) to the base frame (I) using bolts (H2) and lock washers (H6).

Fig. 10 Enlarge

Secure side panels to second front/back panelView in 3D

Secure the side panels (A-1, B-1) to the second front/back panel (C) using bolts (H1), lock washers (H6), and washers (H12).

Fig. 11 Enlarge

Common questions

About the available product information.

TaskHow long does this guide take?

Most people finish in 44–59 min. Go step by step and keep tools nearby before starting.

TaskWhat tools do I need?

You need Pentalobe, Spudger, Tweezers, Heat gun.

ProblemWhat if a part does not line up?

Loosen the previous fasteners, align the part again, and only tighten fully after the connected pieces are seated correctly.

About

Brand

babyletto

Official and community guides for this brand.

Creator

Community

Structured from available product documentation and 3D guide data.